Do Programmable Thermostats Actually Save Money?

A programmable thermostat saves money only when it is programmed and left alone. The device is not the savings, the setback is. DOE’s long-standing rule of thumb is that you can save as much as 10% a year on heating and cooling by turning the thermostat back 7 to 10 degrees Fahrenheit for 8 hours a day. [1] A programmable thermostat makes that happen automatically, which is its whole job.

Found this useful? Send it to someone who needs it.

That figure is a ceiling and it needs conditions: the setback has to be that deep and that long, your equipment has to handle it, and you cannot override the schedule every evening. This page explains where the savings come from, what the evidence does and does not show, the cases where a programmable thermostat saves nothing, and a schedule you can copy and adjust.

Key Takeaways
  • The savings come from the setback, not the device: DOE says as much as 10% a year for 7 to 10 degrees over 8 hours a day. [1]
  • An independent simulation of idealized smart algorithms put average savings at 5-10%, with larger numbers costing comfort. [2]
  • Constant overrides, shallow setbacks and heat pump backup heat are the three ways a programmable thermostat saves nothing.
  • A programmable model is cheaper than a smart one, and smart models are generally easier to use with more reporting. [1]

Where the savings come from

A heating or cooling system uses energy to hold your house at a temperature. The wider the gap between inside and outside, the faster the house loses heat in winter or gains it in summer. Letting the indoor temperature drift while nobody needs it narrows that gap for part of the day, so the equipment runs less. That is the entire mechanism, and it works on any thermostat that can change setpoints, including a manual one you adjust by hand.

DOE describes the target plainly: turn the thermostat down 7 to 10 degrees Fahrenheit for 8 hours a day in the fall and winter to save as much as 10% per year on heating and cooling. [1] The words as much as matter. A home that is empty all day and sleeps with the heat down can approach the top of that range, while a home that is occupied most of the day and run at a mild setpoint will sit far below it.

  • The deeper the setback, the larger the saving, up to the point where recovery becomes uncomfortable or triggers backup heat.
  • The longer the setback, the larger the saving, which is why the workday and the overnight period are the two big blocks.
  • The colder or hotter the climate, the more energy the house exchanges with the outdoors, so the larger the dollar value of each degree.

What the evidence shows, and its limits

The 10% figure is an estimate with a long history. The DOE page carrying it was retired, and the same sentence appears in its newer upgrade guidance: save as much as 10% a year by turning your thermostat back 7 to 10 degrees Fahrenheit for 8 hours a day. [3] Treat it as the upper end of what a disciplined schedule can do.

Newer thermostats have been assessed too. A Lawrence Berkeley National Laboratory simulation of idealized smart thermostat algorithms found that on average 5-10% energy savings are possible, with some homes able to exceed 20% but probably with some discomfort to the occupants. [2]

A plain programmable thermostat relies on the same setback principle, so a good schedule may capture a similar share, though no source cited here measures that directly.

Do Programmable Thermostats Actually Save Money? - What the evidence shows, and its limits

ENERGY STAR measures smart thermostats against a threshold: the lower 95% confidence limit of the weighted national average runtime reduction must be at least 8% for heating and 10% for cooling. [4] Those are runtime reductions on certified smart models, not savings on your bill. The honest summary is that savings in the single digits to about 10% are plausible for most homes, and your own result depends on your schedule.

When a programmable thermostat saves nothing

The device cannot save energy if the setback never happens. The most common ways it fails are behavioral, and each has a fix.

  • Permanent hold or constant overrides. If you press hold on the first cold evening and never release it, you have a manual thermostat. Fix: schedule the comfort times you really want so you stop overriding.
  • Setback so shallow it does nothing. A one or two degree drop barely changes runtime. Aim for the 7 to 10 degree range DOE cites if your house and system can recover. [1]
  • A heat pump on a deep setback. DOE says not to set back a heat pump without a smart or programmable thermostat designed for heat pumps, and not to set it back manually if that causes backup electric-resistance heating to come on. [1] Resistance backup typically costs more per unit of heat than the heat pump itself, so a deep recovery can raise the bill.
  • A house that is rarely empty. If someone is home all day, the only big block is overnight, so the saving is smaller.
  • A leaky house. If the building loses heat fast, the setback gives up temperature quickly and recovery takes longer, which cuts into the gain. Air sealing and insulation make setbacks more comfortable.

A schedule you can copy

Most programmable thermostats offer four periods a day: wake, away, home, sleep. Start with the pattern below, then adjust after two weeks of living with it. The numbers are examples, not a prescription, so change them to match your equipment and comfort.

  • Wake: comfort temperature starting shortly before you get up.
  • Away: set back from the comfort setting for the hours everyone is out.
  • Home: return to comfort shortly before the first person arrives.
  • Sleep: set back again overnight. A cooler bedroom overnight suits many households.
  • For example, with a 68 degree comfort setting, a setback to 60 degrees for the workday is an 8 degree drop, inside the 7 to 10 degree range DOE describes. [1]
  • For example, in summer you might raise the setpoint during the away block and use a ceiling fan when you are home, since DOE says a ceiling fan lets you turn up the thermostat about 4 degrees Fahrenheit without any loss in comfort. [1]

Programmable or smart: when to upgrade

If a programmable thermostat is already in your wall and your schedule is steady, replacing it with a smart model mostly adds convenience. DOE says smart thermostats are generally easier to use and have more reporting and interactive features, while programmable thermostats are cheaper. [1] A smart model earns its price if your schedule changes a lot, if you forget to set the thermostat back before trips, or if the programming interface on your current unit is so awkward that you give up on it.

If you do not have a programmable thermostat at all and you leave the temperature at one value around the clock, any programmable model is the cheapest way to capture the setback benefit. Check wiring and voltage first. Electric baseboard heaters often run on line voltage and need a thermostat made for it. Turn the power off at the breaker before replacing anything, and ask an electrician or HVAC contractor if the wiring is unfamiliar.

A quick payback check

Use your own bills. As a hypothetical, if heating and cooling cost you $1,200 a year and your schedule delivers a 5% saving, you save $60 a year, so a hypothetical low-cost thermostat pays back in about six months. [2] A hypothetical pricier smart model would take over four years at the same saving, which is why the cheaper device often wins on pure payback. Raise the assumed saving toward 10% and both payback times halve, but that requires the deeper, longer setbacks described above.

FAQ

How much can a programmable thermostat save?
DOE says as much as 10% a year on heating and cooling for a 7 to 10 degree setback held 8 hours a day. [1] Most homes will land below that figure, depending on schedule and equipment.

Do Programmable Thermostats Actually Save Money? - FAQ

Are programmable thermostats worth it in a heat pump home?
Only with a model designed for heat pumps. DOE says not to do deep setbacks otherwise, and to avoid any setback that brings on backup electric-resistance heating. [1]

Is a smart thermostat better than a programmable one?
It is easier to use and offers more reporting, but programmable thermostats cost less. [1] If you will keep a schedule, a programmable model captures most of the benefit.

Should I turn the thermostat off completely when I leave?
In very cold weather a full shutoff risks frozen pipes, and in very hot weather it makes for an uncomfortable recovery. Use a setback range and check your equipment’s guidance.

Important

Turn off power at the breaker before swapping a thermostat, and use a licensed electrician or HVAC contractor for line-voltage heaters or unfamiliar wiring. Do not let the house get cold enough to risk frozen pipes. The 10% figure is DOE’s ceiling, not a prediction for your home. [1]

Sources

  1. Tips on Saving Money and Energy in Your Home (Energy Saver Guide, 2022). U.S. Department of Energy, accessed 2026-10-12
  2. Simulation-Driven Rating of Smart Thermostats | LBNL. Lawrence Berkeley National Laboratory, accessed 2026-10-12
  3. Home Upgrades | Department of Energy (Energy Savings Hub). U.S. Department of Energy, accessed 2026-10-12
  4. Smart Thermostats Key Product Criteria | ENERGY STAR. U.S. EPA ENERGY STAR, accessed 2026-10-12

Savings, costs and rebate figures are estimates from the dated sources cited on each page; your results depend on your home, climate and utility rates, and incentive programs change often. Gas, venting and electrical work belongs with a licensed professional. This is general information, not financial, tax or legal advice. As an Amazon Associate we earn from qualifying purchases.

Found this useful? Send it to someone who needs it.
Scroll to Top
© 2026 Energy Bill Action Plan  |  Disclaimer  |  Affiliate Disclosure  |  Privacy Policy  |  Terms  |  About
As an Amazon Associate we earn from qualifying purchases.